The Switchboard RTMP info is located at the top left of the workflow page. Each workflow has it's own stream information.
The easiest way to connect to most encoders not listed in the Switchboard Application is to copy the RTMP URL and Stream Key and paste each value into the stream settings of your live streaming software ( encoder). You can select Other from the Encoder Selection if you are setting up a new Switchboard account.
Step 1:
You will need to have both Switchboard and the live-streaming software open.
Step 2:
In the next steps, you will go back and forth between Switchboard and your encoder as you copy and paste the RTMP URL and Stream Key from the Switchboard Cloud workflow and paste them into the live streaming software.
Step 3:
Copy the RTMP URL and Stream Key from Switchboard and paste them into the stream settings of your encoder.
NOTE: Some encoders ( like Larix Broadcaster) only provide one line for both your URL and Stream Key.
In this case, provide the URL and Stream Key as one string of characters, separated by a forward slash (/).
Stream URL "/" Stream Key.
See below:
Ready to Go Live!
- Start sending video from your encoder to Switchboard Live.
- Verify that the video is displaying in the Switchboard confidence monitor.
- Go Live to your destinations one by one or bulk select using the white box at the top of the destination group.
Read the support article below for additional tips:
Change the Name of your Encoder